Conclusion first: Yes, for your first transfer, it is strongly recommended to send a small test amount first. This is not unnecessary. It is basic self-protection in crypto trading — on-chain transfers cannot be reversed. If you choose the wrong network or enter the wrong address, your funds are gone.
Why send a test transaction first
Crypto on-chain transfers are not like bank transfers that can be reversed or refunded. Once confirmed on-chain, the funds enter the other address and no one can move them.
When sending to a new address for the first time, the three most common mistakes are: copying one wrong character in the address, choosing the wrong network (for example, sending via ERC20 to a TRC20 address), and forgetting to fill in a Memo/Tag when the receiving platform requires it. In these cases, the money is almost impossible to recover. Even if you contact customer service, they usually only check the status and cannot fix it for you.
Send a small test amount first, wait for it to arrive, and then send the rest. That is the easiest way to limit your loss.
Minimum safe steps
Step 1: Copy the receiving address and check the first 6 and last 6 characters
Ask the receiver to open the Binance App or website, go to [Wallet] → [Deposit], select the coin and network, and copy the generated address. When you paste it into the platform you are sending from, manually compare the first 6 and last 6 characters to make sure they match what you copied. Malicious software can change the address in your clipboard, so this step can block many problems.
Step 2: Confirm the network is the same on both sides
This is the most important step. The network you choose when sending must be exactly the same as the network shown on the receiver's deposit page. If the receiver uses BSC, choose BEP20. If the receiver uses TRC20, choose TRC20. If the networks do not match, the money goes to another chain and usually cannot come back.
Step 3: Send the smallest possible amount
Most platforms allow a minimum withdrawal amount of around 10 USDT or equivalent. Send that amount first. No need to send more. After submitting, go to [Withdrawal History], copy the TxID, and check the status in a block explorer.
Step 4: Confirm arrival, then send the rest
After the receiver confirms that the small amount arrived, use the same process to send the remaining amount. Do not change the address or network. Just copy the address that already worked.
Risk reminder: A test transaction itself can also fail
When sending a test transaction, if the sender's account balance is not enough (principal + fee), or if the chosen chain temporarily does not support deposits and withdrawals, the transaction can also get stuck. Also, if a transfer is subject to Travel Rule requirements to a specific platform, Binance may ask you to complete a Satoshi test first. That is basically an official small amount address verification. After completing it, the address will be marked as "verified," and you will not need to repeat verification later.
How to check after the operation is complete
After submitting the test transaction, go to [Withdrawal History] and check the status. Once the status becomes "Completed," ask the receiver to check their [Assets] page to see if the balance has increased. If both sides match, you can send the rest.
