When copy trading losses grow, don't wait — immediately activate the two-level stop-loss: single-order stop-loss + overall project stop-loss. This is the standard risk control feature provided by Binance Copy Trading.
The world's largest cryptocurrency exchange by trading volume,leading in security and liquidity.
New user benefit: Enjoy 20% off trading fees upon registration!
The core logic of setting a stop-loss is to lock in the maximum loss in advance, rather than trying to figure it out after the market moves.
Prerequisites
- Logged in to your Binance account and navigated to the [Futures Copy Trading] or [Spot Copy Trading] page.
- Already opened a copy trading project that is currently in a sustained loss.
- Sufficient USDT balance available in the account for copy trading.
Level 1 Stop-Loss: Single-Order Stop-Loss
This is a stop-loss applied to each automatically copied order. If you set a single-order stop-loss ratio when creating the project, the system will automatically close the position when the loss reaches that ratio, preventing it from dragging on further.
How to do it: In the copy trading project settings, find the "Single-Order Stop-Loss" option (usually presented as a percentage). Enter the maximum loss percentage you're willing to accept for a single order, such as 10% or 15%.
Completion Standard: In the project details page, the "Single-Order Stop-Loss" column shows the ratio you set and the status is "Active".
Level 2 Stop-Loss: Overall Project Stop-Loss
This is the most critical safety net. If the trader suffers consecutive losses and the cumulative loss reaches the percentage you set, the system will automatically end the entire copy trading project, and no further orders from this trader will be copied.
How to do it: In the advanced settings of the copy trading project, find the "Project Stop-Loss" option. Set a maximum total loss percentage you can accept (usually recommended 20%-30%); once exceeded, the system will automatically stop copying and liquidate remaining positions.
Completion Standard: The project settings show the ratio you set for "Project Stop-Loss" and the status is "Enabled".
Why Both Levels Must Be Set
With only a single-order stop-loss, you can be drained by multiple small losses. Suppose a trader has a 60% win rate but a reward-to-risk ratio of 0.5; it's a losing strategy in the long run. Each loss stops at 10%, but every 3 wins barely cover 1 loss, and after 10 trades your capital is eroded. A single-order stop-loss cannot stop this slow bleed.
With only an overall project stop-loss, a single large loss may not trigger the single-order stop-loss (e.g., a loss of 8% when you set 10%), but after several such trades the cumulative loss exceeds 20% and still wrecks the account.
Risk Reminder: The stop-loss in copy trading is a "market order triggered on condition". In volatile markets, slippage may occur, so the actual execution price could be worse than your stop-loss price. Also, when a lead trader uses a limit order to open, the copier's order is triggered only after the lead trader's limit order is fully filled. This means you may miss the entry point during sharp moves, reducing the effectiveness of the stop-loss.
The world's largest cryptocurrency exchange by trading volume,leading in security and liquidity.
New user benefit: Enjoy 20% off trading fees upon registration!
Verification After Setup
Open Binance App [Futures] → [Copy Trading], go to your project details:
- Confirm that both "Single-Order Stop-Loss" and "Project Stop-Loss" have values (not "Not Set").
- Check that both statuses show "Active". If one shows "Triggered" or "Ended", it means risk control has already been executed, and you need to reassess whether to continue copying. Verification channel: Binance App [Copy Trading] project details page.
